CPOC C Development System for the Psion 3a ========================================== CPOC Pre-Processor (CPP) ~~~~~~~~~~~~~~~~~~~~~ 25th January, 1996 INTRODUCTION ~~~~~~~~~~~~ This is the C pre-processor for use with CPOC (release 0.80 or later). It is not intended to be used as a stand-alone program, but via the CPOC front-end program. It therefore needs the CPOC front-end program (part of the "CPOC Starter Pack") to operate. The "CPOC pre- processor" is provided separately to the "CPOC Starter Pack" for two reasons: - Not all users of CPOC may want this part of the system. - We may well want to update one component of the system without updating other parts. The modular nature of CPOC lends itself to this approach. INSTALLATION ~~~~~~~~~~~~ The "CPOC Pre-processor" comprises of the following files: CPP.IMG Pre-processor program README.TXT This file The CPP.IMG file needs to be installed in the directory that you have chosen to hold CPOC program files. Normally this will be a \CPOC\ directory (on any drive). For more information on alternative locations please read the README.TXT file that is provided with the CPOC "Starter Pack" (or the on-line help that is provided as part of the CPOC front-end program). Please also check that there is a copy of the CPOCDYL.DYL file provided with the CPOC "Starter Pack" in the same directory as the CPP.IMG program. If not, you will get a "Panic 222" message when you try and run the pre-processor from CPOC. COPYRIGHT ~~~~~~~~~ The CPOC system is (c)copyright 1995-1996 by K.D. Walker and D.J. Walker All rights reserved. DISCLAIMER ~~~~~~~~~~ Although CPOC has been extensively tested, the authors shall not be responsible for any loss of any kind due to its use. It is the user's responsibility to establish the suitability of the CPOC software for the use to which it to be put.